[. . . ] Water connection Connection to the mains water supply must be carried out by a qualified technician in compliance with the manufacturer's instructions and applicable local safety regulations. The inlet hose must be securely clamped to the water tap to prevent leaks. [. . . ] For Austria: If a fault current switch is fitted upline of the appliance, this must be pulse current-sensitive. Assembly instructions During assembly the appliance must be unplugged from the mains. Leave a gap of at least 3 mm between the top edge of the wooden door and the worktop. Do not seal the gaps between adjacent units and the worktop (for example with silicone). Attention: when transporting and assembling the appliance, always wear gloves to protect fingers / hands from sharp edges and corners. If the appliance is installed at the end of a row of units, making the side panel accessible, the hinge area must be covered to prevent any risk of crushing (cover available from After-sales Service ). Be careful with uneven installation surfaces: Carefully push the dishwasher with feet unscrewed under the worktop. After fitting the plinth and decor panel and before opening the door, evaluate whether the plinth needs to be cut and, if so, how much (see assembly instructions) in order to avoid any damage. The sharp edges of the unit and the plinth must be protected from humidity (with insulating material, for example silicone, not included with the appliance). General indications The appliance must only be used in the household and according its purpose. [. . . ] Sørg for at slangene for vanntilførsel og vannavløp er uten krøll eller bukter. For Østrig: Hvis der før apparatet monteres en fejlstrømsafbryder, skal den være følsom over for pulserende strøm. [. . . ]